Hi guys,
Just wondering if anyone knows what happened to TD 14822............I have
something the present owner might want off the car.....I owned it in college
in the early 70's, it was my only transportation.
Best,
Ray McCrary
"Speed is Life;
of course Luck and Altitude
are helpful, too."
----- Original Message -----
From: "David Tinker" <david.tinker@virgin.net>
To: "Wiedemeyer" <boxweed@thebest.net>
Cc: <mg-t@autox.team.net>
Sent: Saturday, August 12, 2000 1:11 PM
Subject: Re: MGTD Engine Number
> The blank engine tags and the rivets are available from Moss Europe part
no
> 408-770, the rivet 325-230. Do not know where you are located but if in
the
> states you have a Moss there. Any difficulty let me know.
>
> Regards
>
> David Tinker
> ----- Original Message -----
> From: "Wiedemeyer" <boxweed@thebest.net>
> To: "David Tinker" <david.tinker@virgin.net>
> Cc: <MG-t@autox.team.net>
> Sent: Saturday, August 12, 2000 3:06 PM
> Subject: Re: MGTD Engine Number
>
>
> > Where can you get the new octagon-shaped engine plates?
> >
> > Bob
> >
> > >New engine plates are available.
> > >Hope this helps
> > >
> > >David Tinker
> > >51 TD
> > >54 TF
> > >E type ser1
> > >----- Original Message -----
> > >From: "Bill Loubiere" <loubiere@earthlink.net>
> > >To: <mg-t@autox.team.net>
> > >Sent: Saturday, August 12, 2000 1:20 PM
> > >Subject: MGTD Engine Number
> > >
> > >
> > >> I am considering buying a MGTD and need some help on understanding
the
> > >> location of the engine number.
> > >>
> > >> I have found the car and engine number on the plate on the firewall.
> > What
> > >I
> > >> do not understand is how to check the number on the engine to
determine
> > if
> > >> they match.
> > >>
> > >> The fire wall number is XPAG TD2 20---.
> > >>
> > >> A number on the engine head is REF118. There may be a number on what
> > >looks
> > >> like a flat part of the block (right side). There is a screw in the
> > >middle
> > >> of that flat section buy no plate.
> > >>
> > >> Where should the engine number be located?
> > >>
> > >> Any help would be appreciated.
> > >>
> > >> Bill Loubiere
> > >>
> > >>
> >
>
>
|