Dan,
I had the same situation with my PA, plus the needle rollers were rusted and
obviously not enough to fill the space. The TA/TB/TC cars used an oilite
bronze bushing in the brake pedal so that is what I installed on the PA
brake pedal. Works fine. Can't remember the bush size but it was an easily
available oilite bush from the local bearing supplier.
Bob Grunau
PA-0531
-----Original Message-----
From: owner-mg-mmm@Autox.Team.Net [mailto:owner-mg-mmm@Autox.Team.Net]On
Behalf Of Dan and Jenny Fest (Coles Nurseries Inc)
Sent: Sunday, September 07, 2008 10:59 AM
To: mg-mmm@autox.team.net
Subject: P type brake pedal question
Guys:
Yesterday, I removed my brake pedal from it's bracket. Out fell quite a few
long rods which I assume make up the bearing. The problem is that there
isn't
enough of them and I know I didn't loose any. Are thee still available or
has
anyone fitted a bushing of some sort ??
Thanks for the help,
Dan
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
|