Mike, Bob, Lew, etc.
I believe this is what I made mine from, bearing bronze or phosphor bronze.
John Libbert
-----Original Message-----
From: hughes.c.m@worldnet.att.net
To: grunau.garage@sympatico.ca; lpalmer@roundaboutmanor.com;
mg-mmm@autox.team.net
Sent: Tue, 14 Nov 2006 1:11 PM
Subject: Re: PA rear spring front pivot
I recall always seeing them referred to as "bronze" or even "phosphor bronze"
trunnions. Can anyone verify this?
- Mike Hughes -t?t-
> I removed the rear trunnion brass slider blocks and of course they are
> quite worn. What is the recommended "brass" or any other material to make
> these trunnions? Is there a better material than solid brass?
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
________________________________________________________________________
Check out the new AOL. Most comprehensive set of free safety and security
tools, free access to millions of high-quality videos from across the web, free
AOL Mail and more.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|