Gents, I've been advised by more than a few not to use the composit head
gasket but to anneal the solid copper gasket that I have....and use plenty of
copper coat.....ok, I hit the gasket 6 times with my propane torch but it had
little effect. I then switched to MAP gas and have it 4 times with that but
still
little effect. Don Martine sez it must be limp before use........I don't
have oxy-acel, so what do I do?? I don't want to melt it by have someone else
hit it with oxy-acel.......at the Gasket Works web site they are now saying
that
they are not sure solid coppers need to be annealed at all if you use their
goo........
Help!
Terry in Oakland
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|