Ah, Bob? Do you mean the release pints (the ones that get pushed by the
fingers) or the ones that the clutch carrier rides on? 2.90" seems a bit
long for the release pins.
Cheers,
Lew Palmer
-----Original Message-----
From: owner-mg-mmm@Autox.Team.Net [mailto:owner-mg-mmm@Autox.Team.Net] On
Behalf Of J.E.A. Rich
Sent: Sunday, January 16, 2005 1:02 PM
To: William Putnam
Cc: mg-mmm@Autox.Team.Net
Subject: Re: L type clutch question
Bill,
The sun came out and the temperature went up to 10: below freezing!
I have to have my memory jogged a bit and I have done that. I made the
6 pins that I have from #8 grade steel bolts. I never had any originals
so don't know the correct length but the ones I made are 2.90" long and
worked fine. They have a couple of flats on the top to give a surface
for a spanner to screw them in and 1/4" BSF threads on the bottom.
There are 7/16" of threads and the flats are 3/8" long and deep enough
to leave 3/16" of metal for the spanner. I hope this helps.
Cheers, "Bob".
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|