-----Original Message-----
From: John James [mailto:jj@octagon.fsbusiness.co.uk]
Sent: 12 January 2005 21:11
To: 'DB35PA@aol.com'
Subject: RE: bottom rad hose on P type
Don,
Get yourself plenty of rubber grease. It also helps to have the hose
nice and soft (leave it in some boiling water for a while). Push one end
of the hose on (probably the rad end) as far as possible and then swear,
grunt and wrestle like crazy! I know I've done it!
If all else fails, you might be able to shorten the hose a tad, but not
really recommended.
Regards,
JOHN JAMES PB0722 J3656
-----Original Message-----
From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net]
On Behalf Of DB35PA@aol.com
Sent: 12 January 2005 20:30
To: mg-mmm@autox.team.net
Subject: bottom rad hose on P type
Anyone have a "trick" for installing bottom rad hose on my P?
I've tried swearing, grunting and wrestling....
Do I need to remove water pump, rad (God I hope not), or both?
Don B.
/// unsubscribe/change address requests to majordomo@autox.team.net or
try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|