In a message dated 10/28/02 11:09:55 Pacific Standard Time,
cnowlan@mossmotors.com writes:
<< Someone out there must have actual samples of these needle rollers!
Three guys have posted dimensions but all are very different. Andrew says
2mm X 17 (.078"X.669") Dennis says .172" X .750" while Jack advises .094" X
1" Is it possible that a steel or bronze bush is also used in conjunction
with the rollers?? I just spoke to Dennis and he came up with an
alternative of using a 5/8 X 3/4 OD bush and .062" needle rollers. Also how
many needles are required?
>>
Guys, Guys! You are looking for a needle in the haystack.......just use a
bronze bush and be done with it......the original "needle bearing" was a make
shift thing in the first place!
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|