--part1_dc.248609b.261d7a94_boundary
In a message dated 4/5/00 16:14:46, terry@clipsystems.com writes:
<< Dear Folks,
I have been guilty of avoiding replacing my windshield on my MG PA. The
original has de-laminated in one small area, and this will give me the
opportunity to replace the plastic insulation wire, running the
windshield wipers with the proper type. Also the frame has a couple of
small cracks on the inside upper corners about 3/8 of an inch in length.
Can anyone tell me what the frame is made of, so I can strip the chrome,
weld or braze as required before re-plating?
Thank you all,
Terry >>
(terry@clipsystems.com)
--part1_dc.248609b.261d7a94_boundary
Content-Disposition: inline
Return-Path: <british-cars-pre-war-owner@autox.team.net>
Received: from rly-yb04.mx.aol.com (rly-yb04.mail.aol.com [172.18.146.4]) by
air-yb01.mail.aol.com (v70.20) with ESMTP; Wed, 05 Apr 2000 19:14:46
-0400
Received: from triumph.cs.utah.edu (triumph.cs.utah.edu [155.99.188.52]) by
rly-yb04.mx.aol.com (v71.10) with ESMTP; Wed, 05 Apr 2000 19:14:32
2000
Received: (from majordom@localhost)
by triumph.cs.utah.edu (8.9.1/8.9.1) id RAA15672
for british-cars-pre-war-actors; Wed, 5 Apr 2000 17:14:30 -0600 (MDT)
Message-ID: <38EBC806.D8BCB01A@clipsystems.com>
Date: Wed, 05 Apr 2000 16:11:02 -0700
From: terry <terry@clipsystems.com>
X-Mailer: Mozilla 4.61 [en]C-NECCK (Win98; I)
X-Accept-Language: en
MIME-Version: 1.0
To: British Cars Pre War <British-Cars-Pre-War@autox.team.net>
Subject: MG PA Windshield
Sender: owner-british-cars-pre-war@autox.team.net
Precedence: bulk
Reply-To: terry <terry@clipsystems.com>
Dear Folks,
I have been guilty of avoiding replacing my windshield on my MG PA. The
original has de-laminated in one small area, and this will give me the
opportunity to replace the plastic insulation wire, running the
windshield wipers with the proper type. Also the frame has a couple of
small cracks on the inside upper corners about 3/8 of an inch in length.
Can anyone tell me what the frame is made of, so I can strip the chrome,
weld or braze as required before re-plating?
Thank you all,
Terry
--part1_dc.248609b.261d7a94_boundary--
|