Glen;
A long time ago I read about someone filling his differential with Brasso or
some sort of metal polish and running it (raised up on blocks) for a while
to polish the gears. I'm not sure I'd trust the ball/roller bearings after
that trick, though.
Regards, Neil Tucson, AZ
-----Original Message-----
From: Glen Barrett [mailto:speedtimer@charter.net]
Sent: Friday, December 19, 2003 10:12 AM
To: Albaugh, Neil; 'Keith Turk'; land-speed@autox.team.net
Subject: Re: Frictional losses
Back in the early days 50s my mentor bob Fugatt that owned the rear engine
roadster I drove ground and polished the trans gears and this allowed easier
shifting and with the syncros removed. It was a side shifter early ford
trans. Bob was a machinest and sure taught me a lot about taking the time
for proper preparation of all mechanical assemblies. I sure miss him, he was
like a second dad.
Glen
----- Original Message -----
From: "Albaugh, Neil" <albaugh_neil@ti.com>
To: "'Keith Turk'" <kturk@ala.net>; <land-speed@autox.team.net>
Sent: Friday, December 19, 2003 8:56 AM
Subject: RE: Frictional losses
> Keith;
>
> Another factor in gear efficiency is the surface finish of the gear teeth.
A
> gear with very precisely ground teeth mating properly with another similar
> gear will have better efficiency (and generate less heat & wear) than one
> with a rough surface on the teeth. The worst are hobbed gears; the
machined
> finish on those teeth is much rougher than a gear with teeth that have
been
> ground.
>
> Don't Hobbit- grind it :^)
>
> Regards, Neil Tucson, AZ
|