Phil:
I'd use the camphor blocks, because they should provide a higher
concentration/last longer (due to greater volume of the active ingredient).
And-- if some of each block is still there when you open the engine-- you
can rest assured that it was still doing it's job.
Hope this doesn't mean you are taking hiatus from landspeed racing?
Russ, #1226B
-----Original Message-----
From: owner-land-speed@autox.team.net
[mailto:owner-land-speed@autox.team.net]On Behalf Of Phillip Landry
Sent: Friday, September 05, 2003 9:44 PM
To: fosterap@flash.net; land-speed@autox.team.net
Subject: Re: Rust fighting
the reason I had thought about using this was not for my tool box at all,
what I was thinking of doing was putting something like this paper or the
camphor in the intake scope and exhaust header outlets of my motor and then
seal them up. I don't plan on running the motor for a while and may not take
it apart for a while also. What do you guys think? Phil
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|