List,
I'm doing some plumbing on the motorcycle and was wondering what is the
best type (material) of fittings to use to avoid galling. I hope that made
sense. The motorcycle case is aluminum, threaded with 3/8 NPT. Should I
use aluminum fittings, brass, steel or stainless? What is the best thread
sealant? Should I use anti-seize instead of sealant? Just looking for your
thoughts and experiences.
Regards, Tom
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|