I'll second that!
The EAA is a really good source for information on high strength lightweight
fabrication techniques and materials. They're a nice bunch of fellows, too.
Regards, Neil Tucson, AZ
-----Original Message-----
From: Michael L Obrien [mailto:Michael_L_Obrien@raytheon.com]
Sent: Tuesday, January 07, 2003 9:40 AM
To: ardunbill@webtv.net
Cc: Albaugh, Neil; land-speed@autox.team.net;
owner-land-speed@autox.team.net
Subject: Re: Welding vs Brazing
There have been quite a few postings on welding and fab. Since racecar and
aircraft weld and fab are both somewhat related,
some of you racers might want to check out the EAA (Experimental Aircraft
Association) site and look at the videos they have
available. They might answer many of your questions.
ardunbill@webtv.net
Sent by: To:
albaugh_neil@ti.com (Albaugh, Neil), land-speed@autox.team.net
owner-land-speed@aut cc:
ox.team.net Subject: Welding vs
Brazing
01/07/2003 08:46 AM
Please respond to
ardunbill
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|