land-speed
[Top] [All Lists]

Re: Roll cage construction

To: "Dick J" <lsr_man@yahoo.com>, <ARDUNDOUG@aol.com>,
Subject: Re: Roll cage construction
From: "John Beckett" <landspeedracer@email.msn.com>
Date: Wed, 23 Feb 2000 16:06:29 -0500
Dick

1 5/8" is fine, 1 3/4" is bigger. Dont' see any reason to mix the two sizes.

John Beckett, LSR #79


---- Original Message -----
From: "Dick J" <lsr_man@yahoo.com>
To: <ARDUNDOUG@aol.com>; <land-speed@autox.team.net>
Sent: Wednesday, February 23, 2000 2:39 PM
Subject: Roll cage construction


>
> OK, I'm going to start work on the cage.  Double
> hoops over my head and one under the dash, all
> tied together with a zillion smaller tubes, but
> what SHOULD I use, as opposed to what MUST I use.
>  I was going to make the three main hoops out of
> 1 3/4 X .120, then tie them together with smaller
> 1 5/8 but still .120.  Is this a good formula or
> not???   The car is only about a buck and a
> quarter car now, but I have some hemis that I may
> use later if the car handles.  I might as well
> build for 175mph. Anybody got thoughts on this.
>
> =====
> .............................
> ..........Dick J.............
> ......(In East Texas)........
> ....FX/GMR  SC/P250-2........
> .....Shelby  427 Cobra.......
> .Hemis and Flatheads Forever.
> .............................
> Do You Yahoo!?




<Prev in Thread] Current Thread [Next in Thread>