OK, I'm going to start work on the cage. Double
hoops over my head and one under the dash, all
tied together with a zillion smaller tubes, but
what SHOULD I use, as opposed to what MUST I use.
I was going to make the three main hoops out of
1 3/4 X .120, then tie them together with smaller
1 5/8 but still .120. Is this a good formula or
not??? The car is only about a buck and a
quarter car now, but I have some hemis that I may
use later if the car handles. I might as well
build for 175mph. Anybody got thoughts on this.
=====
.............................
..........Dick J.............
......(In East Texas)........
....FX/GMR SC/P250-2........
.....Shelby 427 Cobra.......
.Hemis and Flatheads Forever.
.............................
Do You Yahoo!?
|