healeys
[Top] [All Lists]

[Healeys] O/D Problem Fixed

To: Healeys <healeys@autox.team.net> vX0kuXvHWsKCO6Lj9RUZuav3j8G+sUhHLBiGqft0DkIa74spOh4+XAKNbPwqe70YXdRwi3k9FDw5EVpDRJi2GxIWiZn7lO5Ywiw=
Subject: [Healeys] O/D Problem Fixed
From: Bob Spidell via Healeys <healeys@autox.team.net>
Date: Tue, 17 Nov 2026 16:11:10 -0800
Authentication-results: autox.team.net; header.b="S09cXHb2"
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
User-agent: Mozilla Thunderbird
Xfinity-graffiti: 05205020929
Xfinity-qid: TTGZxPgjGw9rCTTGZx3Ath
Finally pulled the tunnel and futzed with the circuits. It turns out, it 
was a faulty (dash/fascia) switch. I fooled myself thinking, because I 
had the dash switch and the shifter knob switch wired in parallel one 
would work even if the other wouldn't (and vice versa). I had the two 
wires each ganged up on the dash switch, and when we pulled it out it 
fell apart. My basic understanding of electronics is that a parallel 
circuit will be live when any other circuit is wired to it proved not to 
be the case. I can't for the likes of me explain why, but that's what we 
found and fixed. Must have been a ground or short in the dash switch; 
the new one, sourced from Moss via Tom Monaco appeared to be better 
quality (that's the second one that's gone bad one me).

While I was debugging I got to  wondering: 'If the solenoid went bad, 
could you just replace the coil (the plunger is free to fall)?'  I know, 
to be extra careful super-duper sure you need to readjust the throw but, 
in a pinch it would be a lot easier than swapping the whole solenoid and 
readjusting the plunder throw.

Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75

Archive: http://www.team.net/pipermail/healeys 
http://autox.team.net/archive/healeys

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net

<Prev in Thread] Current Thread [Next in Thread>