If the end play was excessive--like, more than none--adding a 0.003"
shim would make it 0.003" greater.? If the original end play you felt
was due to a loose bearing retaining nut then tightening it is probably
what fixed the problem.
Bob
On 7/2/2018 8:04 AM, Tom Felts wrote:
> OK----update.? This morning pulled wheel/hub/bearings. bearings looked
> good.? Did find some in/out movement when pulling on the hub.? Right
> or wrong, I add a .003 spacer and really snugged the hub nut down.?
> put back together and all was good--no more noise and everything is
> smooth.
>
> tom
> ----- Original Message -----
> From: Tom Felts <tomfelts at windstream.net>
> To: healeys at autox.team.net
> Sent: Sun, 01 Jul 2018 20:45:05 -0400 (EDT)
> Subject: [Healeys] snap crackle and pop
>
> When turning hard to the right (slow moving) I get a lot of these
> noises at the left front wheel area.? Assume it is the tie rod?? I
> first thought it was a loose spinner but that was not it.? Any ideas?
> tom? BJ8
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180702/c98c47f5/attachment.html>
|