I presume you have wired the pump valve plunger up so it clears the cam on the
main shaft.
John
-----Original Message-----
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Bob
Spidell
Sent: Tuesday, February 20, 2018 9:08 AM
To: Healeys <healeys at autox.team.net>
Subject: [Healeys] Mating OD to gearbox
Folks,
I've successfully (hopefully) rebuilt and upgraded my OD and gearbox, but can't
seem to get them to, uh, mate properly. I had aligned the splines in the rear
of the OD with my mainshaft before assembling the gearbox, but even then they
didn't want to merge and, of course, after several tries the splines became
misaligned (and I don't have a much-desired spare mainshaft). I've done my
best to get the splines aligned by prodding with a screwdriver but, even with
them visibly aligned the two won't slip together. I tried dozens of test
fittings, and got them to join one time, but didn't have the pump can or gasket
installed, so that was for naught. Any suggestions?
TIA,
Bob
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|