Kilmartin finishers fit. However, the door handle strike could keep the
finisher from fitting properly and you might have to enlarge the holes in the
finisher.
JohnBT7
On Monday, February 12, 2018 9:43 PM, Linwood Rose <linwoodrose at mac.com>
wrote:
As I recall, and I could be wrong because it was ten years ago, I had the same
situation. The ill fitting set was from one of the usual vendors. I believe I
ordered a set from Kilmartin and they were spot on. Check with Kilmartin and
see if they sell them.?Lin
Sent from my iPad
On Feb 12, 2018, at 5:23 PM, Per Schoerner <per at schoerner.se> wrote:
DanIt looks like the shut panel can go a little bit further towards the center
of the car, there is a gap there. On the other hand it doesn?t look like it
will fit anyway. Do you still have the originals? So you can compare them.
Per
Skickat fr?n min iPhone
12 feb. 2018 kl. 20:43 skrev Corning, Dan (D.C.) <dcorning at ford.com>:
#yiv6444579971 #yiv6444579971 -- .yiv6444579971EmailQuote
{margin-left:1pt;padding-left:4pt;border-left:#800000 2px solid;}#yiv6444579971
Everything was going very smoothly installing the new Bristleflex door seals
and lower aluminum trim set.? Too smoothly??A trial fit of the door shut finish
set revealed the protrusion on the top is misaligned.? Anyone experienced this
before??(The dotted line suggests what I?m thinking about)?<IMG_0333.JPG> Best,
Dan Corning
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180214/47be20cc/attachment.html>
|