Could be an issue with the float not bottoming out.
John Spaur BT7
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Tim Davis
BN7
Sent: Monday, October 23, 2017 4:58 PM
To: healeys <healeys at autox.team.net>
Subject: [Healeys] Fuel tank questions
In the past I have responded to a fuel tank repair questions extolling the
virtues of using tank sealers and my tank which I sealed 15 years ago recently
started leaking. Anyway I had an aftermarket tank originally from Sports and
Classics that I obtained from somewhere and after pulling mine out and test
fitting the other I see that the filler neck is at a slightly different angle.
I think I can get it to connect up but wanted to know if anyone sees this as a
non Healey tank. The fuel output fitting and sender unit flange are correct.
It also appears to be a bit smaller and the tank bottom where the drain is
located is a little different, i.e. 2 circular protrusions rather than one
rectangular one. Please see photos, the filler necks may look different
diameter but are the same.
Tim Davis BN7
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20171024/a6e08489/attachment.html>
|