The only diffenence is the speedo cable has a different size. You can use the
BN2 BJ8 angle drive on all the transmissions and then use the BN4 BT7 speedo
cable.
I have the piece for the speedo drive now
David Nock
British Car Specialists
209-948-8767
www.britishcarspecialists.com
From: Michael MacLean
Sent: Wednesday, August 16, 2017 11:26 AM
To: Bob Spidell ; healeys at autox.team.net
Subject: Re: [Healeys] BN2 Speedo Angle Drive
OK, I am now told by my transmission rebuilder not to use the BN1 angle drive
because the cable end of the drive is a different size thread than the 4 speed
transmission.
Mike MacLean
On Wednesday, August 16, 2017 11:15 AM, Bob Spidell <bspidell at comcast.net>
wrote:
Moss lists it in their catalog. Pricey as hell--$229.99--but they should have
them. Part# 768-020.
On 8/15/2017 7:22 PM, Michael MacLean wrote:
I need the speedo angle drive unit that screws into the overdrive for my
transmission rebuild going on right now. There are no angle drives available
for the BN2 4 speed side shift trans so the big retailers are offering the BN1
speedo angle drive for the BN2 transmission. Since the gearing is different,
will the speedo be off because of this? Will I merely need to get the speedo
re-calibrated?
Mike MacLean
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
--------------------------------------------------------------------------------
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170816/32e2184f/attachment.html>
|