I have to replace the timing chain cover gasket on a 1967 BJ8. Would someone
please tell me how much I have to remove from the engine to raise it high
enough to remove the crankshaft pulley. Thanks.
Regards,
Charlie
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Simon
Lachlan
Sent: Friday, February 10, 2017 12:47 PM
To: 'Healey List'
Subject: [Healeys] Fuel Gauge dampener
Hi,
I?d saved something relating to damping the fluctuations in my fuel gauge. I
don?t recall if it was originally posted here or if I trawled it off the net.
I?d made a few notes and filed it appropriately against some day in the future
when I might get round to actually doing it.
So, my nephew?s fuel gauge bounces around far more than mine and this prompted
me to dig out the article/notes.
First off, I agree that there?s no sense in putting the capacitor anywhere near
the fuel tank.
Having said that, I read the advice that I?d stored so carefully and began to
wonder if I?d understood it correctly.
Is the capacitor really supposed to be wired across the two terminals on the
gauge? Would it have any effect? To put it crudely, but in the language that I
can understand, wouldn?t the fluctuations still come down the Green/Black wire
from the sender unit and hit the gauge?s terminal T? And wouldn?t those
fluctuations still register as such on the gauge, totally unaffected by the
capacitor?
Shouldn?t the capacitor be wired in such a fashion that the fluctuations cannot
bypass it?
Maybe I?m over complicating things and should just try it without understanding
it. Maybe I think too much.
Simon
--------------------------------------------------------------------------------
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170210/3783dde5/attachment.html>
|