The bolt patterns are the same. The dowel pins are in different locations.
They are interchangeable IF you get new dowel pin holes drilled at a machine
shop. I recommend the BJ8 pressure plate as it is smoother and more
positive clutch engagement action..
Warm Regards,
Tracy Drummond
PMP | ITIL Service Manager | CISSP | bighealey@charter.net | 408-394-3444
cell | 408-776-0133 home | http://www.linkedin.com/in/tracydrummond
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of warthodson@aol.com
Sent: Friday, September 07, 2012 5:13 AM
To: healeyguy@bredband.net; healey.nut@gmail.com
Cc: healeys@autox.team.net
Subject: Re: [Healeys] Clutch/Release/Pressure Plate Questions
I was pretty sure the bolt pattern was different, but do not have two
different flywheels to double check this.
Can someone provide the definitive answer?
Gary Hodson
From: Per Schoerner <healeyguy@bredband.net>
To: Alan Seigrist healey.nut@gmail.com
Hi
Alan is right, of course everything can be modified. What I meant was that
the unmodified BJ8 clutch fits only to the unmodified BJ8 flywheel.
And I may remember incorrectly, the dowel pattern may possibly be the only
difference.
Per
Alan Seigrist skrev 2012-09-07 05:31:
> If the dowels line up to your clutch cover, then the flywheel is
> correct. Otherwise there is no material difference. Even if the
> dowels don't match, alot of the times, you can reposition them at a
> machine shop because the bolt patterns are the same.
$12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://autox.team.net/mailman/options/healeys/bighealey@charter.net
_______________________________________________
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|