Thanks for the information, but the master cylinder and calibers were
rebuild originals.
I have read about the issues with the Moss units on British Car Forum. I
understand that Moss is no longer selling the master cylinders and has a new
source. That said, the rebuild kits for both the clutch and brake master
cylinders for this car did come from Moss, but the clutch master cylinder
kit is working fine. I will call Moss tomorrow and inquire.
Ron
From: i erbs [mailto:eyera3000 at gmail.com]
Sent: Sunday, August 07, 2011 8:07 PM
To: Ron Ray
Cc: healeys at autox.team.net
Subject: Re: [Healeys] Front disc brakes locking up after rebuild
Just got an email from a fenders saying Moss had a recall on some master
cal. Don't know any more than that. If you have a Moss unit. Contact them.
On Aug 7, 2011 5:50 PM, "Ron Ray" <ronald-ray at sbcglobal.net> wrote:
> Folks,
>
> After rebuilding the hydraulic system the front brakes do not release. If
> the bleed screw is loosened, they do release.
> The rear brakes do not lock up
>
> All rubber hoses were replaced.
> All original steel brake lines were clean with air pressure.
> The connector valve on the passenger side was removed and cleaned with air
> pressure.
> The caliber pistons can be moved by hand when they are off the car.
>
> When the front brakes lock up, the master cylinder piston does not return
to
> the full "forward:" position.
>
> Any suggestions would be greatly appreciated.
>
> Thanks
> Ron
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/eyera3000 at gmail.com
|