John.. something is cockeyed and tightening makes it worse. Was it dropped?
Best case is that the Bellville washers are too thick or not centered. No
end thrust on main shaft.
Does it still turn or only that the selector rods are binding?
Dave
frogeye@porterscustom.com
Porter Customs 2909 Arno NE
Albuquerque, NM USA 87107
505-352-1378
1954 BN2 1959 AN5
Porter Custom Bicycles
cars:
www.britishcarforum.com/portercustoms.html
gallery:
http://picasaweb.google.com/porterscustombicycles/PorterCustomBicyclesStuff
GO HERE: http://porterbikes.com/ nice pictures-fun facts-my world
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of John Morrison
Sent: Wednesday, August 03, 2011 10:12 PM
To: healeys@autox.team.net
Subject: [Healeys] Transmission rebuild
I have a BN7/BT7 transmission that has been taken apart and is now
reassembled. Problem: When the bell housing is tightened up the trans
won't go into neutral. If the cap screws are loosened 3/4 turn it will go
into neutral.
What have we done wrong?
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/frogeye@porterscustom.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|