I believe Hylomar works great under compression between two flat
parts but I don't think it would make a good filler sealant which is
what you might need in this application. Just a guess on my part though.
John, BT7
At 02:39 PM 3/22/2011 -0400, you wrote:
>I'm putting a redi-sleeve over the rear axle shaft where the oil
>seal rides, and the instructions say to use a non-hardening sealant
>inside the sleeve before sliding it over the shaft. I thought of
>using Hylomar, but I thought I'd heard somewhere that people used
>lock-tite in this application.
>What does the collective wisdom of the list say?
>
>Stephen, BJ8
>_______________________________________________
>Healeys at autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/jmsdarch at sbcglobal.net
>
>__________ Information from ESET Smart Security, version of virus
>signature database 5976 (20110322) __________
>
>The message was checked by ESET Smart Security.
>
>http://www.eset.com
|