I am installing the wiring and noticed that the fuel pump wire is too
short to reach the pump connection. I have a LHD BT7 with the pump on
the right side.
The wiring diagram shows an in-line bullet connection that was used
to extend the wire to reach the pump. My harness was spliced to
extend the wire (it may have burned at one point because a green wire
was spliced onto the white wire.
Would and in-line bullet connection be correct for extending the wire
to reach the pump or should a new harness be supplied with a
continuous wire of the correct length?
Thank you,
John
'62 BT7
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|