The ones on our (mostly) original BN2 were bent over. Exposed wire was just
long enough to be bent back and almost
reach the base of the connector.
bs
On 12/1/2010 4:38 PM, I Erbs wrote:
> Tail light wire bullets. Are the wires soldered on the end or bent over.
> Memory says bent. If bent how long should exposed wire be?
> Ira Erbs
> Digs 4 Solutions
> Computer Consultants
> Portland, OR
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/bspidell@comcast.net
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|