healeys
[Top] [All Lists]

Re: [Healeys] A-Frame bushing space measurement needed

To: healeys@autox.team.net
Subject: Re: [Healeys] A-Frame bushing space measurement needed
From: healeyguy@aol.com
Date: Wed, 06 Oct 2010 03:14:39 -0400
John
Just measured a set of original bushings (the ones that have more than just a
steel sleeve through the rubber) and they are just 0.875 long. Times two
equals 1.75 inches. The opening between the A-arm frame mount with bolt (pin
assembly) in place is 1.81 inches. Theoretically there is a slight gap between
the bushings when assembled using original parts. Suggest a slight trim with a
grinder to get the 0.901 bushings just a bit shorter. Easy to do.
Aloha
Perry






-----Original Message-----
From: john spaur <jmsdarch@sbcglobal.net>
To: healeys@autox.team.net
Sent: Tue, Oct 5, 2010 8:01 pm
Subject: Re: [Healeys] A-Frame bushing space measurement needed


Thanks!
Two possible suppliers; I am not sure which one.
John

At 07:19 AM 10/4/2010 -0700, Patrick Yoas wrote:
>I have .901 on my measurement.
>My bushings came from Tom's Imports.
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/healeyguy@aol.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>