The set screws need to be pointed, and they need to set immediately in front
of the inner beveled flange to lock it in place so it turns with the wheel,
and so it can't come out. The conical end allen set screw will not work
here. It must be pointed.
Rich
--------------------------------------------------
From: "Ron Ray" <ronald-ray@sbcglobal.net>
Sent: Sunday, April 18, 2010 9:42 PM
To: <healeys@autox.team.net>
Subject: [Healeys] Trafficator
> Folks,
>
> Do the three set screws that go through the steering wheel hub tightened
> against the edge of the back plate of the turn signal switch?
> Or do the go in front or back of the plate?
>
> The lower screw hole on my hub, for an original Derringer steering wheel,
> does not appear to be in alignment with the other two holes
>
> I have two of the original pointed set screws. If somehow I manage to get
> the third hole to work, will a standard allen head set screw with the
> slightly conical end work?
>
>
> Thanks.
> Ron Ray
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|