When I installed my Pertronix, I had to retime the engine to get it to work
smoothly as Alan suggested. Simple procedure but it was necessary for me and
now the engine hums.
John Sims, BN6
Aberdeen, NJ
http://www.healey6.com
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Alan Seigrist
Sent: Sunday, April 11, 2010 7:20 AM
To: john doe; Healeys@autox.team.net
Subject: Re: [Healeys] Mallory dist
John -
Did you put the plastic rotor on the dist. cam?
Also, check your timing, I notice sometimes these kits put timing off
by as much as 30 deg, so you need to re-time the ignition, that should
fix it.
On 4/11/10, john doe <rccpl1@yahoo.com> wrote:
> To all the guru's out there i have a bj8 with a mallory dual point dist
the
> car is neg ground and i purchased a pertronics 11 ignition kit .The
> instructions seem simple enough but i can't get the car to start.there's a
> module on the side of the dist i don't know if thats a condenser or a
> ballast do i attach it now and were to anyone done this thanks
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/ahbn6@verizon.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|