healeys
[Top] [All Lists]

Re: [Healeys] camber

To: Dave Porter <frogeye@porterscustom.com>
Subject: Re: [Healeys] camber
From: Dave Russell <rusd@sitestar.net>
Date: Sun, 10 Feb 2008 12:37:15 -0700
--===============0963527080==
Content-Type: text/plain; charset=windows-1250; format=flowed
Content-Transfer-Encoding: 7bit

The term camber as referred to a leaf spring is the amount of curvature 
of the spring leaves.

An unloaded spring placed on a flat surface might have the eye ends 
several inches higher than the spring center/axle attachment. This 
difference is called free camber. Eg- A spring might have 3 3/4" of 
difference, positive camber.

When the same spring is installed & loaded it flattens out to the 
position called loaded camber. This might typically be zero - flat,  
slightly positive - still a bit of curve upward on the ends, or negative 
- center higher than the ends.

The shop manual for a BN1-2, shows a free camber of 3 3/4". When loaded 
to 490 pounds the spring should have about 1/4" of negative camber. A 
total of 4" deflection from no load to full load.

Dave Russell
BN2

Dave Porter wrote:

>Bob,
>    Camber is of course the way that the tire and wheel stand vertically, so
>I can't see how the spring would affect it at all.  That would be controlled
>only by the axle housing.  The only thing that I can see that the spring
>could control would be the angle of the pinion shaft relative to the
>horizontal.  The spring could of course have a front and rear, as well as a
>top and bottom.  I think someone isn't interpreting the book correctly.  I
>would be interested in the responses as well.   Then again, maybe I didn't
>understand the question ?? I'll pull the book off the shelf and read what
>Rodger was saying ASAIGAC
>Dave                                               
>
>frogeye@porterscustom.com
> 
>Porter Customs
>Albuquerque, NM USA 87107
>505-352-1378
>1954 BN2
>Porter Custom Bicycles
>www.britishcarforum.com/portercustoms.html

--===============0963527080==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline

_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

--===============0963527080==--

<Prev in Thread] Current Thread [Next in Thread>