I intend to install a drivers side floor exhaust insulation panel but I'm not
sure how the fixing studs are attached. I did purchase the correct studs
from Brit. Car Spec. and I have the panel to put on, but my car didn't
originally have this panel so I am clueless.
#1 I don't weld. Can I attach these flat head studs from either the inside
or
outside with JB weld and hope it holds.
#2 If I do install these from the inside of the car by drilling holes in
the floor is that defeating the purpose cause the heat
may travel up the studs to the inside of the car anyway.
Thanks, Mark
|