fot
[Top] [All Lists]

[Healeys] Spring - BJ8 Gearbox

Subject: [Healeys] Spring - BJ8 Gearbox
From: bspidell at comcast.net (Bob Spidell)
Date: Tue, 25 Apr 2017 10:19:36 -0700
References: <MWHPR19MB11049275574E3C57743C546ED11E0@MWHPR19MB1104.namprd19.prod.outlook.com> <CABXhz88zbdRg4L2UiDqQ4YbqyTCpKjYCYpVXZnXLuapKhEtrDQ@mail.gmail.com>
Jean,

I still have my original, and it's a bit of a pain to install--you need 
three hands--but nothing like this.  Can only suggest you may have to 
grind the outer part of the 'last ring' to make it fit; doubt that would 
compromise performance or strength very much.

Bob


On 4/25/2017 9:47 AM, i erbs wrote:
> bigger hammer?
>
> Ira Erbs
> Portland,OR
>       _______                          _______
>      (______ \____1959 BN4____/ _______)
> (_________________________)
>           BT7 engine and disk brakes
>
> A racing car is an animal with a thousand adjustments. Mario Andretti
> Please excuse random auto corrects and misspelled words
>
> On Tue, Apr 25, 2017 at 8:33 AM, Jean Caron 
> <vintage_roadster_restoration at hotmail.com 
>
>     Has anyone replaced the gear shifter retaining spring lately on a
>     center shift 4 speed gearbox. I am replacing one now with a new
>     spring and I am having a difficult time with it. I have replaced
>     several in the past but cannot remember having such difficulty
>     with it. It seems that the last "ring" of the spring is too large
>     and it does not want to go in its place to fit the washer.
>     Consequently I cannot even think of fitting the circlip into its
>     groove.
>
>
>     Jean
>
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20170425/913d5bac/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>