It can be done but you need the special seal washers and ideally new
bolts and torque them to the set values. Better is to get new or
properly rebuild ones if you are not accustomed rebuilding callipers.
They are relatively cheap.
Kees Oudesluijs
Op 18-2-2017 om 19:24 schreef Mike Tobin:
> Hi All,
> Time to attack the front calipers on the BT7. They've been sitting
> for over 30 years and are really sad looking.
> I'm thinking the only way I'm going to get a purchase on them to get
> them out is to split the calipers. The factory manual, however, sez
> (in BOLD) to not attempt this. Why is this? In the archives folks
> say it can be done. Anything I have to watch for other than being
> clean and careful?
> Cheers and Thanks,
> Mike Tobin
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs
> at chello.nl
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170218/0a2d1ccf/attachment.html>
|