I did get the message but don't have any alternate suggestions for
rear seal if the crank is machined for the earlier seal kits.
- Tony Drews
At 06:57 PM 1/20/2017, Joe Boruch via Fot wrote:
>Not sure if this went thru before, since I did not receive it in my
>inbox and did not receive any replies. Sorry for the duplication,
>if it went out previously.
>
>The recent discussion of the valve cover gasket reminded me to ask
>about TR3/4 rear main seals. I know that the new improved Viton
>seals are make to fit cranks that the scroll surface has not been
>machined. All my cranks have been machined to fit the earlier seal
>kits. Is there an upgraded seal kit to fit machined cranks or would
>there even be any advantage to using the new seal? Joe(B)
>
>
>fot at autox.team.net
>
>http://www.fot-racing.com
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/fot/tony at tonydrews.com
|