Not to worry, this is the later head (off a Mk III)
Jason
On Mon, Jun 30, 2014 at 10:58 AM, SCOTT JANZEN <sjanzen@me.com> wrote:
> If it's a mk I head, toss it and find a mk II
>
> Sent from my mobile device
>
> > On Jun 30, 2014, at 10:38 AM, Jeff Durant <jeff_durant@comcast.net>
> wrote:
> >
> > Jason,
> >
> > GT6 mk1 or plus (mk2) head?
> > Regards,
> >
> > Jeff Durant
> > #12 TR6
> >
> >
> > Sent from my iPhone
> >
> >> On Jun 29, 2014, at 1:07 PM, Jason Sukey <jsukey@gmail.com> wrote:
> >>
> >> I'm getting ready to mill the head on my GT6 for a bump in compression.
> I
> >> currently measure 3.255" thickness, my math shows that I want to end up
> at
> >> 3.215" when I'm done. I can't find much info on how far people are
> safely
> >> milling the GT6 version of this head, only TR6 info. Does anyone have
> >> experience on this? Is there enough meat in the casting to remove this
> >> much material without hitting water?
> >>
> >> Thanks,
> >>
> >> Jason Sukey
> >> _______________________________________________
> >> fot@autox.team.net
> >>
> >> http://www.fot-racing.com
> >>
> >> Donate: http://www.team.net/donate.html
> >> Archive: http://www.team.net/archive
> >> Forums: http://www.team.net/forums
> >> Unsubscribe/Manage:
> > http://autox.team.net/mailman/options/fot/jeff_durant@comcast.net
> > _______________________________________________
> > fot@autox.team.net
> >
> > http://www.fot-racing.com
> >
> > Donate: http://www.team.net/donate.html
> > Archive: http://www.team.net/archive
> > Forums: http://www.team.net/forums
> > Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/sjanzen@me.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|