[Fot] A-Type O/D Conversion Shift Tower Issue

[Glenn Franco <gaf3@charter.net>]

Hi All

I'm converting an early TR6 Trans to Overdrive.
The issue I'm having is drilling and tapping the shift tower for the 
lock out switches.
The installed back up lamp switch has a thread pitch of 2mm per my 
thread gauge and the O.D. is just shy of 16 mm.
I'm assuming a 16mm x 2 tap. Is this correct?


The second issue I'm having is the oil pump plunger refuses to come out 
of the housing.
The eccentric on the output shaft was completely worn out. I'm guessing 
there's an issue there.
Any suggestions for removal?

Thanks in advance
Glenn
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive