We found the knurl to be different on the Southwick axles than the stock front
TR3. Summit had long studs with the correct knurls for each in 7/16 size. They
were Morso studs.
Sent from my iPhone
On Mar 20, 2013, at 7:38 PM, "J.C. Hassall" <jhassall@blacksburg.net> wrote:
> Anyone happen to know the OD of the press-in wheel studs for TR4-6? Most of
the p/n I've found are just a tad over the 0.494 ID I've measured in the hub,
so the knurl OD could be a sticky issue. I need longer studs in 7/16x20
thread, so need to order larger and drill the hubs. Anyone have a favorite
p/n?
>
> tnx
>
> jim
>
> --
> Jim Hassall
> Blacksburg VA
> '63 TR4 in autox preparation
> 99% finished, 90% to go
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/jhhasty@gdhs.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|