Re: [Fot] TR4-6 wheel stud knurl OD?

[Hugh Barber <tr6nut@verizon.net>]

Jim,

I'm using ARP P/N 100-7708 "12mm x 1.50 Late Model GM/Corvette". These 
will press into TR6 hubs
without re-drilling the holes and are 3" long.  They are metric so you 
have to use the appropriate metric lugnuts.

Hugh Barber
Stafford, VA




On 3/20/2013 7:38 PM, J.C. Hassall wrote:
> Anyone happen to know the OD of the press-in wheel studs for TR4-6?  
> Most of the p/n I've found are just a tad over the 0.494 ID I've 
> measured in the hub, so the knurl OD could be a sticky issue.  I need 
> longer studs in 7/16x20 thread, so need to order larger and drill the 
> hubs.  Anyone have a favorite p/n?
>
> tnx
>
> jim
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive