Glenn,
I have recently started making triple choke cables and have then in stock
with either solid wire or stranded cable.
Regards,
Richard Good
--------------------------------------------------
From: "EDWARD BARNARD" <edwardbarnard@prodigy.net>
Sent: Wednesday, March 03, 2010 9:13 PM
To: "Friends of Triumph" <fot@autox.team.net>; "Glenn Franco"
<gaf3@charter.net>
Subject: Re: [Fot] Choke Cable
> Glenn: I have installed three of these set-ups for customers; a couple of
> which are on the six-pack list (customers, not carbs). I have always set
> them
> up on the back two carbs, and have never had a problem starting. Make sure
> the
> cams are adjusted correctly, and that the enrichening (sp?) discs and
> holes
> are not plugged up.
> Thanks - Ed
> --- On Wed, 3/3/10, Glenn Franco <gaf3@charter.net> wrote:
>
>
> From: Glenn Franco <gaf3@charter.net>
> Subject: [Fot] Choke Cable
> To: tr6parts@charter.net, "Friends of Triumph" <fot@autox.team.net>,
> 6pack@autox.team.net
> Date: Wednesday, March 3, 2010, 5:13 PM
>
>
> With the recent thread on the 6 pack email list, I have a couple of
> questions
> for the wisdom of the collective groups.
> Just installed a triple stromberg (Good setup) on a rebuilt early TR6
> engine
> with a cam this past fall. The only problem I have is during starting, it
> takes more than two carbs to start the beast. I need a third cable to
> connect
> to the center carb to get it going. after that it runs to problem.
> Any one else had this issue? I have the front and rear carbs on the cable.
> The
> center carb is not contributing to the starting event.
> All three carbs were extensively rebuilt including throttle shafts and
> seals.
> Any ideas out there??
> Thanks in advance
> Glenn Franco
> \
\
_______________________________________________
fot@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|