Glenn: I have installed three of these set-ups for customers; a couple of
which are on the six-pack list (customers, not carbs). I have always set them
up on the back two carbs, and have never had a problem starting. Make sure the
cams are adjusted correctly, and that the enrichening (sp?) discs and holes
are not plugged up.
Thanks - Ed
--- On Wed, 3/3/10, Glenn Franco <gaf3@charter.net> wrote:
From: Glenn Franco <gaf3@charter.net>
Subject: [Fot] Choke Cable
To: tr6parts@charter.net, "Friends of Triumph" <fot@autox.team.net>,
6pack@autox.team.net
Date: Wednesday, March 3, 2010, 5:13 PM
With the recent thread on the 6 pack email list, I have a couple of questions
for the wisdom of the collective groups.
Just installed a triple stromberg (Good setup) on a rebuilt early TR6 engine
with a cam this past fall. The only problem I have is during starting, it
takes more than two carbs to start the beast. I need a third cable to connect
to the center carb to get it going. after that it runs to problem.
Any one else had this issue? I have the front and rear carbs on the cable. The
center carb is not contributing to the starting event.
All three carbs were extensively rebuilt including throttle shafts and seals.
Any ideas out there??
Thanks in advance
Glenn Franco
3 TR6's , TR250, Spit race car and a nice 76 rust free spit.
\
_______________________________________________
fot@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/edwardbarnard@prodigy.net
\
_______________________________________________
fot@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|