How did you adhere it to the upper / lower steel parts of the
standard rear mount?
- Tony
At 03:08 PM 2/14/2010, gasket.works@gte.net wrote:
>I had a company make a rectangular piece of urethane of ?durometer
>(I can't recall). About three foot legnth minimum order. It was
>pliable yet tough and machinable. I dissasembled the std rear mount
>and used the upper and lower steel parts sandwiching the urethane
>between. Had to do a little bit of trickery to isolate the top from
>the bottom but, that was nearly 10 years ago. Not a peep out of it.
>
>M
>Sent via BlackBerry from T-Mobile
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.96
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
|