I had a company make a rectangular piece of urethane of ?durometer (I can't
recall). About three foot legnth minimum order. It was pliable yet tough and
machinable. I dissasembled the std rear mount and used the upper and lower
steel parts sandwiching the urethane between. Had to do a little bit of
trickery to isolate the top from the bottom but, that was nearly 10 years ago.
Not a peep out of it.
M
Sent via BlackBerry from T-Mobile
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.96
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
|