> FOT, I'M REBUILDING A TR 6 TRANS THAT I INTEND TO INSTALL IN A TR3. ADVISORS
> SAY THAT THIS WELL WORK. ALL OF THE PARTS I'VE GOT SO FAR SEEM
> INTERCHANGABLE
> WITH ALL MODLES EXECPT THE BRG FOR THE INPUT SHAFT THAT CONNECTS TO THE MAIN
> SHAFT. I'VE ORDERED THIS TWICE AND IT DOES NOT FIT. ANY IDEAS? THANKS, KEN M.
There were two different bearings used for TR6, the early bearing had the outer
race incorporated while the later bearing ran directly against 4th gear (the
input shaft). The early bearing was a light press fit and a PITA to remove ...
perhaps the outer race is still inside the shaft ?
I assume you know that the front cover needs to match the clutch ... TR6 front
cover is shorter than the TR3.
Randall
|