Chucks Aluminum Hubs are sweet- I do not know why anyone would run a roller
bearing on the Axle again- Check them out! I run them with custom Summers
Axles -
John W.
Spitfire #892
2004 Kastner Cup
----- Original Message -----
From: <Chasgee@aol.com>
To: ""Rob Stewart"" <robstewart@telwares.com>; <fot@Autox.Team.Net>
Sent: Tuesday, January 04, 2005 11:43 AM
Subject: Re: Spitfire Competition Billet Axles
> Rob,
>
> If you want to upgrade further, I make an aluminum hub that takes larger
> bearings. It utilizes a bearing sleeve so that the roller bearings aren't
> in direct contact with the axle. Increases axle life considerably.
>
> Let me know if you are interested. I can probably get you a package deal
> with a local axle manufacturer too.
>
> Chuck Gee
> Spitfire #14
>
> In a message dated 1/3/2005 5:13:16 PM Eastern Standard Time, "Rob
> Stewart" <robstewart@telwares.com> writes:
>
>>All:
>>
>>I'd like recommendations and any information available on procuring a new
>>set of billet steel axles for my vintage race Spitfire. I haven't had to
>>look for these in quite some time and don't know who is still making them,
>>or what the experience (good or bad) folks have had with the various
>>suppliers.
>>
>>Any information is greatly appreciated.
>>
>>Best regards,
>>
>>Rob Stewart
>>1967 Spitfire #6
|