I appreciate that Richard. These are beautiful parts, is there any way to
make them without a tip roller--maybe a fixed rubbing block that pins in to
replace the roller? If that was an option the block could be swapped in when
an organization objects, but the needle bearing would still be retained.
I suspect a few more people could use them in that case. the bushing rockers
are really marginal. I took apart three sets to find enough rockers with
good bushings.
-----Original Message-----
From: Richard Good
To: Bill Babcock
Sent: 5/8/2004 6:56 PM
Subject: Re: rockers and pushrods
Bill,
You may return them for a full refund of the parts price.
Richard
Bill Babcock wrote:
>richard,
>The parts are very pretty, but I can't use them. I thought you were
sending
>me rockers with pin bearings, didn't realize they are rollers. I can't
run
>rollers at either Monterey or the Wine Country race at Sears.
|