I had to install an 8ohm ballist resistor but only after I installed a 6AL
MSD box,This was the specked resistor per the MSD instructions prior to
the msd install the bat. cut off work fine on its oun
----- Original Message -----
From: "Charly Mitchel" <charly@mitchelplumbing.com>
To: "Chuck Arnold" <chuck.arnold@oracle.com>; <6pack@autox.team.net>;
<Fot@autox.team.net>
Sent: Friday, April 02, 2004 10:22 AM
Subject: Re: Fist time ever I have to repeat a question
> Chuck, I have the same concern and have looked around with no avail.
Charly
> ----- Original Message -----
> From: "Chuck Arnold" <chuck.arnold@oracle.com>
> To: <6pack@autox.team.net>; <Fot@autox.team.net>
> Sent: Thursday, April 01, 2004 6:43 PM
> Subject: Fist time ever I have to repeat a question
>
>
> > I asked if anyone knew, or has an instruction sheet regarding, what
> resistor
> > value is needed for a battery cutoff switch that includes the terminals
> for
> > shutting off the alternator. The point is with these "FIA" cutoff
> switches,
> > if the engine is running and the switch is turned to off the alternator
is
> > stopped from continuing to run the car even though battery is cut off.
No
> > responses were forthcoming, so I am tying again with a little more
> > information.
> > Thanks
> >
> > Chuck Arnold
> > Technical Manager
> > Oracle Northwest Fulfillment Practice
> > 425 241 0457 [cell]
|