If I understand the question correctly, I think the instruction page I
scanned in long ago at the bottom of
http://www.tonydrews.com/Tony_Car.htm (sheet is at
http://www.tonydrews.com/Kill_Switch2.jpg ) shows a value of 3 ohm, 11
watt. Your mileage may vary.
- Tony Drews
At 08:43 PM 4/1/2004, Chuck Arnold wrote:
>I asked if anyone knew, or has an instruction sheet regarding, what resistor
>value is needed for a battery cutoff switch that includes the terminals for
>shutting off the alternator. The point is with these "FIA" cutoff switches,
>if the engine is running and the switch is turned to off the alternator is
>stopped from continuing to run the car even though battery is cut off. No
>responses were forthcoming, so I am tying again with a little more
>information.
>Thanks
>
>Chuck Arnold
>Technical Manager
>Oracle Northwest Fulfillment Practice
>425 241 0457 [cell]
|
