Russ,
On my TR4 I used 1/2" Moroso studs. I'm not positive but I think they
had 7/16" also.
Rich Hone
> ----------
> From: Russ Moore
> Sent: Wednesday, June 10, 1998 11:42 AM
> To: 'Amici Triumphi'
> Subject: wheel studs -HELP!
>
> I seem to runs into walls on this locally and wondered what the rest
> of you
> do if anything. Any help would be appreciated.
>
> I am looking for a wheel stud either with the same shank or a bit
> larger in
> diameter than a stock TR-6 front stud. This will need to have about 1
> 7/8
> thread up to a max of 2". I have dog-eared the book of NAPA options
> and
> Dorman pieces and purchased a dozen that were "supposed" to be right
> only
> to find they had some odd shank configuration. What I am trying to do
> is go
> to a stronger wheel attachment in the Spit (7/16 over 3/8) which is
> the
> same as TR-2/6. The stock TR-6 front studs fit perfectly but are too
> short
> to allow the use of the alloy rims and/or any spacers.
> A Guiness to the lad with the solution to my dilemma.
>
> Thanks
> Russ Moore
>
|