From 311 site, this is method #2 which I found easier than trying to figure
out when valve was closed etc
"With 1/2" ratchet and a large socket put the engine
on top dead center dizzy rotor pointing to #1 spark plug wire cap
position, and adjust #1 rockers, then rotate the crank 180 degrees and
check both rockers on # 3(rotor will be pointing to #3 cap position)
then rotate again 180 degrees which is to the timing mark and adjust #
4 rockers then 180 and adjust #2 rockers. It usually takes 3-4 tries to
get them good enough to quiet down.
Rotor on dizzy will be pointing to 1 3 4 2 as you rotate which is the firing
order.
Valves are closed when adjusting via this method."
-----Original Message-----
From: BRAD MORROW <tumorrow@msn.com>
To: datsun-roadsters@autox.team.net
Sent: Fri, 3 Apr 2009 2:38 am
Subject: [Roadsters] Tappets
Anyone have step-by-step instructions on how to adjust tappets on an SPL311
roadster?
You are subscribed as ljordan704@netscape.net
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|